You should see an xterm window at the top left of the screen with the foo $ prompt and possibly very small fonts. You can do most of the rest of the configuration from here. The OpenBSD base includes an ancient version of fvwm as the default window manager. The softraid disk is renumbered to sd1 as the USB stick has been removed. ![]() I had to change the default to sd2 and proceed with the installation. The installer asks which disk to use to install OpenBSD to and on this laptop the default was sd1 which is the USB stick. sd2 is the softraid partition that the installer creates.sd0 is the main disk in the laptop that I am installing to.Finally you will be asked to specify which disk to install the package sets to.ĭrive numbering during installation on this laptop. Then the installer will create the softraid device but not mount it. If you answer to that question you will be prompted for a passphrase to unlock the disk. The OpenBSD 7.3 installer has a new question asking if you want to encrypt the main disk. OpenBSD FAQ - Disk Setup -Full Disk Encryption.Prepare to visit 2001! Alternate install with encrypted hard driveĪpril 12th: This section is not well-tested and is based on a single quick trial. Reboot into the graphical log-in screen and type your username and password. The default is so I had to type: Europe/London You need to answer Yes to the question about the missing SHA256.sig file.Then type the label of the USB stick (probably sd1) In the section Let's install the sets! you have to specify that.Answer Yes to the question about the X Window System being started by xenodm. ![]() ![]() You need to select non-default options at four stages in the installation.
0 Comments
Leave a Reply. |